Tooling
MACH-1 Step Pulley Kit
The Step Pulley Kit is for kneemills that have shorter drawbars. Other than a drawbar sized to fit such machines, this kit has everything the Full Kit does. [Note: Not all components are pictured above, and components are not shown to scale. See the material listing below.]
| Stock# | Part | Price* |
|---|---|---|
| 38-22-26-002 | MACH-1 Step Pulley Kit | 1495.00 |
| 38-22-26-111 | 7/16" R-8 Collet | |
| 38-22-26-030 | Drawbar Assembly | |
| 5/8" x 1" positioning washer material | ||
| Drawbar coupling assembly | ||
| Acorn nut | ||
| Top spring washer | ||
| 7/16"-14 spring compression nut (2) | ||
| Bottom spring washer | ||
| 1" x 4" die spring with plastic tube | ||
| 38-22-26-190 | R-8 Collet Tightening Fixture Assembly | |
| 3/8" lock washer | ||
| 3/8" x 2" carriage bolt | ||
| 3/8"-16 nut | ||
| R-8 collet tightening fixture | ||
| 38-22-26-070 | Reference Manual | |
| 38-22-26-144 | R-8 Jacobs J33 Chuck Adapter | |
| 38-22-26-052 | 3/16" Pin Spanner Wrench | |
| Actuator Assembly | ||
| 5" diameter actuator plate | ||
| 1/4"-20 soft-tip set screw | ||
| Plastic cap (red) | ||
| 1/4"-20 x 3/4" BHCS (3) | ||
| Actuator cap | ||
| 6mm x 3/4" SHCS (3) | ||
| 38-22-26-191 | Tooling tray | |
| 38-22-26-109 | 3/8" R-8 Collet | |
| Setting gage | ||
| 38-22-26-133 | 1/2" R-8 Endmill Holder | |
| 38-22-26-121 | 3/4" R-8 Collet | |
| 38-22-26-103 | 3/16" R-8 Collet | |
| 38-22-26-117 | 5/8" R-8 Collet | |
| 38-22-26-131 | 1/4" R-8 Endmill Holder | |
| 38-22-26-105 | 1/4" R-8 Collet | |
| 38-22-26-101 | 1/8" R-8 Collet | |
| 38-22-26-107 | 5/16" R-8 Collet | |
| 38-22-26-132 | 3/8" R-8 Endmill Holder | |
| 38-22-26-113 | 1/2" R-8 Collet | |
| 38-22-26-115 | 9/16" R-8 Collet | |
| 38-22-26-119 | 11/16" R-8 Collet | |
| 38-22-26-100 | R-8 Collet Closer (4) | |
*Pricing in $US is subject to change without notice.
